Steps for adjusting the buckle gap of the nail button machine

First, understand the fastening machine buckle gap

Nail fastening machine buckle gap refers to the size of the gap between the connecting nail and the slot hole, the size of the gap directly affects the strength of the buckle and the quality of the nail. Therefore, it is very necessary to adjust the buckle gap.

Second, find out the adjustment screws of the fastening machine

The location of the adjusting screw of each buckle machine may be different, but usually in the lower or side of the nail knife. To find the adjustment screw and loosen it.

Third, adjust the buckle gap

1. Secure a piece of prepared sheet metal to the nailer.

2. Nail and check down the tenon and groove holes in the buckle, if the connection is not tight, buckle strength is not enough, you need to increase the buckle gap, and vice versa, you need to reduce the gap.

3. Adjust the screws of the fastening machine, gradually adjust to a satisfactory degree of fastening.

4. After the adjustment, check again whether the connection is tight, if necessary, you can continue to fine-tune.

IV. Precautions

1. When adjusting the buckle gap, be sure to operate carefully to avoid damaging the machine or injuring yourself.

2. Before adjusting, be sure to disconnect the buckling machine and wait for the machine to stop running before proceeding.

3. After the adjustment, tighten the adjusting screws to prevent the screws from loosening and affecting the normal operation of the machine.