Reasons for severe wear and tear on fully automated buckling machines

Fully automated buckling machine is mainly used in metal components hot riveting, such as car beam riveting, highway bridge riveting, riveting of mining vehicles and other riveting work, but also can be used for other work that must be caused by the impact of kinetic energy public places, such as shovel cutting metal materials, casting parts combing, completely eliminate burrs and weld slag. The first can be used for hot riveting of metal components, such as the riveting of beams, highway bridge riveting, riveting of mining vehicles and other riveting work. Can also be used for other must cause impact kinetic energy work public occasions, such as shovel cut metal materials, casting, completely eliminate burrs and welding slag.

1、Belt direction deviation. Roller rubber wear, roller group rollers work abnormally and other hazards belt direction deviation. Belt deviation of the rollers at the higher place suffers quite a big working pressure. Long time working roller just wear and soften, until cracked. Roller wear more is shown in the dumping before the belt section.

2、The gray belt of the buckling machine belt is sticky with dust. Brush piece wear, did not stick to the belt surface layer, ash viscosity enhancement, high moisture content. The belt surface layer is equipped with slag pipe belt conveyor.

3, ash moisture content is high. Overconsideration of slag water filter cartridge filter and water pipe blockage, water conservancy gate drain clogging, slag clearing after water filtration parts are not timely cleaned, resulting in ash with too much is water.

4, cache slag box ash is straight. Residue equipment of the residue in a certain period of time and did not dry, immediately by the column tube belt conveyor to the drying box, the drying box will be composed of more is the residue and water, and the column tube belt conveyor will enhance the full load hours and enhance the wear and tear of the roller drum.

5, Quality of needle roller bearings. Some roller workbench cleaning, due to the rolling bearing product quality problems will also lead to insensitive or seized shift, followed by wear and tear.

6, poor confinement characteristics of the buckling machine. Coal ash is organized into the roll rolling bearing, composed of blocking or change sensitivity and composed of wear. Slurry ash wear to the rollers. Sometimes the slurry ash originating from the slaker is simply coupled to the belt and falls onto the carriers and work rollers on both sides of the rollers. On the one hand, the roller body wear, on the other hand, it coagulates and agglomerates.

7, in the rollers wear has a large particle size of the ash slag. Sometimes, from the slag machine's very large residual ashes stick to the tape, hard and sharp raw materials in the roller body quickly wear out!